| Steps |
Roughen
Cap Nut installed
|
We won't need an Axle Brace with the Power Cycles.
Their wide back end supports the axle just fine, so, we can
use the same length as stock. The Cold Rolled steel
will bend less easily.
Measure and mark the steel shaft at 20
inches.
Cut the shaft off at the mark.
With a file, or outside on the cement, file off the rough corners that the hacksaw
made. Next, on the cement, roughen up about 1/2 inch of both ends of the shaft.
Scrape around the shaft. This will help give the Cap Nut something to grab
onto when you assemble later. |
